Weld part & lock inspection, before the robot fires.
Advitiix AI-Inspect® verifies every clamp, lock, and part position on the weld fixture in real time - releasing the welding robot only when the assembly is fully locked and correct.
- Industry
- Automotive Tier-1
- Coverage
- Every fixture cycle
- Outcome
- Zero unlocked welds
One missed clamp ruins the weld
If a single clamp or lock is open when the welding robot starts, the part shifts - leading to scrap, rework, and unplanned downtime on a high-volume line.
Vision AI confirms every lock
An overhead camera checks every clamp position on the fixture, identifies the loaded model, and only signals the robot to start when all locks are confirmed.
Robot starts only when safe
Operators see live lock status on a model-specific dashboard, and the robot interlock releases only on a full PASS - protecting cycle time and weld quality.
Pick the model, see every lock.
One screen the operator actually uses - model selection on the left, live fixture status on the right. The robot waits for a green board.
Every clamp, every cycle, every model.
Per-clamp lock detection
Every clamp on the fixture is detected and tracked individually with a clear locked/unlocked state.
Model-aware checks
Each part model has its own lock map - the system validates against the right pattern automatically.
Robot interlock
The welding robot start signal is released only on a full PASS, preventing welds on an unlocked part.
Cycle-time safe
Inference runs in seconds at line rate, with full history retained for traceability.
Bring AI-Inspect® to your weld shop.
Share a fixture you want to protect - we'll show you what Advitiix can lock down.